Category Archives: Meeting Posts

On Saturday, We had some problems connecting to the robot and running the code we had recently made up. After careful screening of the code we made, we found out that one small difference was stopping from the robot to … Continue reading →

Today we worked on brackets, both for the turret motor and the brackets that will hold the plexiglass up on the sides of the robot. The plexiglass will help support the robot by connecting the four posts and also be … Continue reading →

The rings for the robot have now all been glued one, and we also have the motor brackets made for the bane bots. The turret motor was mounted as well that is going to be geared with the lazy susan … Continue reading →

We glued on the rings to one roller, but unfortunately we ran out of super glue, so we’ll finish them tomorrow at school. We also replaced the shafts for the rollers since they were threaded, instead getting solid ones since … Continue reading →

Today we mounted one of the electronics board, the higher horizontal one. We also finished the rings that will go on the rollers to keep the belts evenly spaced. They will be glued on tomorrow. And we also finally got … Continue reading →